Abstract

With the emergence of readily available simple J solutions for various types of structures through J estimation techniques, J-integral-based elastic-plastic fracture mechanics has become a common tool for analyzing ductile materials. This paper presents elastic-plastic solutions for semi-elliptical surface flaws of four different crack depths. Solutions are developed from a series of finite element analyses using the ABAQUS computer program with a deformation plasticity material constitutive law. Although the solutions are directly applicable to a single set of Ramberg-Osgood material parameters, they may be extended to include various amounts of strain hardening by a ratioing technique utilizing calibration functions from the EPRI handbook for continuous flaws. This paper addresses cylindrical structures loaded by internal pressure, and excludes any consideration of thermal loadings. Elasticplastic J solutions, determined for pressures up to 5000 psi (12700 Pa), or twice the design pressure, depart from plastic-zone-corrected linear elastic predictions at approximately 3000 psi (7620 Pa) pressure. The h1 plastic calibration functions derived in this paper are limited to the point of greatest crack depth in 6:1 aspect ratio semi-elliptical inside surface flaws in cylindrical pressure vessels.

1.
ABAQUS User’s Manual, Version 4.7, 1988, Hibbitt, Karlsson & Sorensen, Inc.
2.
Bloom, J. M., 1983, “A Procedure for the Assessment of the Structural Integrity of Nuclear Pressure Vessels,” ASME Journal of Pressure Vessel Technology, Vol. 105.
3.
Bloom, J. M., 1985, “Extension of the Failure Assessment Diagram Approach—Semi-Elliptical Flaw in Pressurized Cylinder,” ASME JOURNAL OF PRESSURE VESSEL TECHNOLOGY, Vol. 107.
4.
deLorenzi
H. G.
,
1982
, “
Elastic-Plastic Analysis of the Maximum Postulated Flaw in the Beltline Region of a Reactor Vessel
,”
ASME JOURNAL OF PRESSURE VESSEL TECHNOLOGY
, Vol.
104
, pp.
278
286
.
5.
Killian, D. E., and Yoon, K. K., 1992, “Elastic-Plastic Analysis of Reactor Vessel Longitudinal Flaws,” Fracture Mechanics: 22nd Symposium, Vol. I, ASTM STP 1131, American Society for Testing and Materials, Philadelphia, PA pp. 248–267.
6.
Kumar, V., German, M. D., and Shih, C. F., 1981, “An Engineering Approach for Elastic-Plastic Fracture Analysis,” NP-1931, Electric Power Research Institute.
7.
Kumar, V., German, M. D., Wilkening, W. W., Andrews, W. R., deLorenzi, H. G., and Mowbray, D. F., 1984, “Advances in Elastic-Plastic Fracture Analysis,” NP-3607, Electric Power Research Institute.
8.
Newman
J. C.
, and
Raju
I. S.
,
1980
, “
Stress-Intensity Factors for Internal Surface Cracks in Cylindrical Pressure Vessels
,”
ASME JOURNAL OF PRESSURE VESSEL TECHNOLOGY
, Vol.
102
, pp.
342
346
.
9.
Yoon
K. K.
,
Bloom
J. M.
,
Pavinich
W. A.
, and
Slager
H. W.
,
1985
, “
Application of the Failure Assessment Diagram to the Evaluation of Pressure-Temperature Limits for a Pressurized Water Reactor
,”
ASME JOURNAL OF PRESSURE VESSEL TECHNOLOGY
, Vol.
107
, pp.
192
196
.
This content is only available via PDF.
You do not currently have access to this content.