Gas film bearings offer unique advantages enabling successful deployment of high-speed microturbomachinery. Current applications encompass micro power generators, air cycle machines, and turbo expanders. Mechanically complex gas foil bearings are in use; however, their excessive cost and lack of calibrated predictive tools deter their application to mass-produced oil-free turbochargers, for example. The present investigation advances the analysis and experimental validation of hybrid gas bearings with static and dynamic force characteristics desirable in high-speed turbomachinery. These characteristics are adequate load support, good stiffness and damping coefficients, low friction and wear during rotor startup and shutdown, and most importantly, enhanced rotordynamic stability at the operating speed. Hybrid (hydrostatic/hydrodynamic) flexure pivot-tilting pad bearings demonstrate superior static and dynamic forced performance than other geometries as evidenced in a high-speed rotor-bearing test rig. A computational model including the effects of external pressurization predicts the rotordynamic coefficients of the test bearings and shows good correlation with measured force coefficients, thus lending credence to the predictive model. In general, direct stiffnesses increase with operating speed and external pressurization, whereas damping coefficients show an opposite behavior. Predicted mass flow rates validate the inherent restrictor-type orifice flow model for external pressurization. Measured coast-down rotor speeds demonstrate very low-friction operation with large system time constants. Estimated drag torques from the gas bearings indirectly validate the recorded system time constant.
Skip Nav Destination
e-mail: Lsanandres@mengr.tamu.edu
Article navigation
July 2006
Research Papers
Hybrid Flexure Pivot-Tilting Pad Gas Bearings: Analysis and Experimental Validation
Luis San Andrés
Luis San Andrés
Mast-Childs Professor
Fellow ASME
Mechanical Engineering Department,
e-mail: Lsanandres@mengr.tamu.edu
Texas A&M University
, College Station, TX 77843-3123
Search for other works by this author on:
Luis San Andrés
Mast-Childs Professor
Fellow ASME
Mechanical Engineering Department,
Texas A&M University
, College Station, TX 77843-3123e-mail: Lsanandres@mengr.tamu.edu
J. Tribol. Jul 2006, 128(3): 551-558 (8 pages)
Published Online: March 1, 2006
Article history
Received:
June 22, 2005
Revised:
March 1, 2006
Citation
San Andrés, L. (March 1, 2006). "Hybrid Flexure Pivot-Tilting Pad Gas Bearings: Analysis and Experimental Validation." ASME. J. Tribol. July 2006; 128(3): 551–558. https://doi.org/10.1115/1.2194918
Download citation file:
Get Email Alerts
Related Articles
Rotordynamic Performance of Flexure Pivot Hydrostatic Gas Bearings for Oil-Free Turbomachinery
J. Eng. Gas Turbines Power (October,2007)
Compliant Hybrid Journal Bearings Using Integral Wire Mesh Dampers
J. Eng. Gas Turbines Power (March,2009)
Design and Performance Prediction of Hybrid Air Foil Thrust Bearings
J. Eng. Gas Turbines Power (April,2011)
Related Proceedings Papers
Related Chapters
Summary and Conclusions
Bearing Dynamic Coefficients in Rotordynamics: Computation Methods and Practical Applications
Supporting Systems/Foundations
Handbook on Stiffness & Damping in Mechanical Design
Average Shaft Centerline Plots
Fundamentals of Rotating Machinery Diagnostics